Do you know where the wire bonder is mainly used

The wire mesh welding machine is mainly used for concrete pouring of bridges, water conservancy, expressways, national key projects, etc. the width of the welded mesh can reach 2.5 meters, the length can reach 12 meters, and the welding diameter is 6 mm ~ 12 mm. The welding machine also has the working environment requirements, the ambient temperature is between 4 ℃ and 39 ℃, the air humidity is not greater than the altitude and the altitude is not more than 2000m.

The inlet water temperature should be in the range of 4 ℃ ~ 45 ℃. The water inlet pressure should be the necessary flow rate of the welding machine, and the water quality should meet the industrial water rules. The surrounding air, dust, acid, corrosive gases or substances do not exceed the normal content. After being wet or soaked in water, the wire bonder must be complete and dry, and can be used in front of safety after being inspected by personnel.

Under the above two conditions, the power supply voltage (when the frequency is rated value) is not more than 10%, and the frequency fluctuation (when the voltage is the rated value) is not more than 1%. The higher harmonic of the power grid is within the scope of the national standard.

Qualified leakage protector shall be used at the main incoming line end of the power supply branch circuit of the wire bonder. The wire bonder and its auxiliary equipment must be grounded and maintained in accordance with the relevant national standards. The mesh welding machine is mainly used for concrete pouring of bridges, water conservancy, expressways, key projects, etc. the width of the welded mesh can reach 2.5 meters, and the length can reach 12 meters. How should the welding diameter stop taking care of the mesh welding machine.

After using the wire mesh welding machine, it is necessary to check whether the cable binding is in accordance with the standard, and whether the chain between the cable war scales is damaged, etc. It is necessary to check the switch handle of the wire mesh welding machine and whether the screw of the internal travel switch can be tightened. It is also required to check whether the solenoid valve of the mesh welding machine is normal. If there is a problem, it should be handled in time.